CTC Union 588400001, Руководство по установке и обслуживанию

Страница: 8 / 44

8 CTC EcoAir 610M / 614M / 622M 400 V 3N~
Checklist
The checklist must always be completed by the installation engineer
• If a service is performed, you may be required to provide this document.
• Installation must always be done according to the installation and maintenance
instructions.
• Installation must always be carried out in a professional manner.
Following installation, the unit must be inspected and functional checks performed
as indicated below:
Pipe installation
†
Heat pump filled, positioned and adjusted in the correct manner according to the
instructions.
†
The heat pump is positioned so that it can be serviced.
†
Capacity of the charge/radiator pump (depending on type of system) for the flow
required.
†
Make sure there is flow.
†
Open radiator valves (depending on type of system) and other relevant valves.
†
Tightness test.
†
Bleed the system.
†
Check proper operation of the requisite safety valves.
†
Action taken to deal with condensation water.
Electrical installation
†
Safety switch.
†
Correct and taut wiring.
†
Requisite sensors fitted.
†
Heat pump activated and started.
†
Accessories.
Customer information (adapted to the relevant installation)
†
Start-up with customer/installer.
†
Menus/controls for selected system.
†
Installation and Maintenance Manual handed over to the customer.
†
Check and filling, heating circuit.
†
Information on fine adjustments.
†
Alarm information.
†
Functional test of safety valves fitted.
†
Register your Installation Certificate at ctc.se. (ctc-heating.com).
†
Information on fault reporting procedures.
____________________________________________ _______________________________________________
Date/Customer Date/Installer