CRZ ERZ Series, Руководство пользователя

Страница: 109 / 127

109
(3) Remove the mounting bolts of the cradle fork and the triangular linkage arm, and
remove the mounting bolts under the shock absorber;
(4) Remove the rear fork to install the shaft and remove the rear fork from the frame;
(5) Clean the oil seal, needle bearing and spacer with diesel oil. Check whether there is
any damage during cleaning, whether the needle is missing or not, and whether the bearing
and the spacer are rusted. If necessary, please replace the bearing and spacer. If the bearing
rotates normally, the oil seal is not damaged. After all the parts are dry, the oil seal, needle
bearing and inner bushing are evenly applied with lubricating oil;
(6) Put the removed materials back in order, lock everything.
Note :
When installing the spacer, oil seal and bolt back, do not install the wrong size.
4. Spacer and bearing of front wheel
If you always ride in wet, muddy or dusty environments, regularly clean, inspect and
lubricate hub bearings and axle spacers are very necessary.
(1) Place a bench under the engine to make the front wheel off the ground;
(2) Loosen the axle nut, hold the front wheel, pull out the front axle, and remove the
front wheel from the front shock absorber;
(3) Remove the axle spacer;
(4) Check the hub bearing for looseness and axial sway. If the rotation is difficult or
abnormal, please replace the bearing; clean the front axle, oil seal, bearing, spacer and hub
surface, and apply lubricating oil on the oil seal and the axle spacer;
(5) Put the axle cover back, install the front wheel, properly insert the friction plate,
install and tighten the front wheel nut.
Note: