Crystal Vision
Using the front control panel
SYNNER-E 3G User Manual R1.2
50
10/09/2012
Sync override will force the SYNNER-E 3G into delay mode when the external sync is
incorrect.
Output freeze when selected will cause the output to freeze and show the selected pattern.
These are selectable from the following list; the last frame shown, Black Matte or Blue Matte.
Video timing controls
In delay mode the video delay is a straight forward fixed bulk video delay that can be adjusted
in samples, lines and whole-frame steps up to a maximum of 3.5 video frames.
When switched to synchroniser mode the initial delay will vary between 0-1 frame depending
on the timing between the input video and external reference. Further fixed delays can then be
added for matching purposes.
The Dolby E compensation delay allows a further 0.5 frame delay to be added to the video
delay to ensure correct Dolby E alignment. Along with an increase in the video delay the PCM
audio delay will also be further delayed by a similar amount allowing the user to avoid a
potential problem with aligning Dolby E.
Note:
For the relevant progressive video standards two video frames are the length of one
interlaced frame. The sample and line control will only make adjustments of one frame of
either progressive or interlaced video.
Video gains
The video proc-amp allows adjustment of video gain, black level and independent YUV gains.
The maximum increase in overall gain allowed is 200%, should any combination of controls
be set where this maximum would be exceeded the gain will be limited to 200%
Note:
It is possible to set the gain control so that their combined indicated gain will exceed 200%.
In these circumstances the indicated values will not be valid.
Audio controls
From the STATUS top menu, rotate shaft control to select the Audio control menu. Press F1
and then rotate shaft control access the audio control sub menu options. To enter a sub menu
once selected press F1, use the shaft control to traverse that sub menu.
The audio control menu contains all of the De-embedder, Embedder gain and routing controls.
