Crystal Vision
Using the front control panel
SYNNER-E 3G User Manual R1.2
49
10/09/2012
Video Timing
Rotate the shaft control and press F1.
Video delay
Rotate the shaft control to view the video timing in samples.
Press F1 and rotate the shaft control to adjust.
0, 2640.
Video delay
Rotate the shaft control to view the video timing in lines.
Press F1 and rotate the shaft control to adjust.
0, 1125.
Video delay
Rotate the shaft control to view the video timing in frames.
Press F1 and rotate the shaft control to adjust.
0, 1.0, 2.0.
Dolby E
compensation
delay
Rotate the shaft control to view the Dolby E compensation
delay in frames.
Press F1 and rotate the shaft control to adjust.
0, 0.5.
Video Gain
Rotate the shaft control and press F1.
Overall video gain
Rotate the shaft control to view the overall video gain.
Press F1 and rotate the shaft control to adjust.
0-200%.
Y component gain
Rotate the shaft control to view the Y component gain.
Press F1 and rotate the shaft control to adjust.
0-200%.
Y component lift
Rotate the shaft control to view the Y component lift.
Press F1 and rotate the shaft control to adjust.
10%.
U component gain
Rotate the shaft control to view the U component gain.
Press F1 and rotate the shaft control to adjust.
0-200%.
V component gain
Rotate the shaft control to view the V component gain.
Press F1 and rotate the shaft control to adjust.
0-200%.
Input mode
The SYNNER-E 3G has the option of either receiving an optical input or transmitting an
optical output once the necessary SPF optical module has been fitted. If the optical receiver
module is fitted the fibre optic I/O input select will allow the video input to be selected
between the input BNC and the optical input.
With the optical output fitted the number of outputs will be reduced from two to one.
Mode selection
Setting the mode to synchroniser will lock the output to the incoming external reference to
compensate for timing delays within the video system. Selected Delay mode make the
SYNNER-E 3G become a fixed delay line.
Should the input signal go away the output will freeze. The ‘On loss of input’ control allows
the user to select the frozen output. The selection is; Last Frame, Black, Blue, or after a delay
of 2 seconds Delay Then Black, Delay Then Blue.
