Crystal Mountain Storm Cafe, Руководство по обслуживанию, Страница: 24 / 37

24
Fig. 4 Fig. 6
Notice:
The information and/or procedures presented in the following demonstration(s) should be performed by a trained Water Cooler
Service Technician only.
Never attempt to service or repair a water cooler while it is plugged into any power supply.
Prior to any service or repair of the water cooler, ensure that the water has been completely drained from the system.
Note: Begin with the unit unplugged, the water drained, and the back panel removed. Tip: Use a small flathead screwdriver to pry
wire terminals and relay from compressor.
1. Remove the relay/overload cover by prying the metal clip to unhook it from the compressor on both sides (Fig. 1 & 2).
2. Carefully remove relay and overload from compressor (Fig. 3, 4, 5 & 6). Remove and identify the wire terminals from the relay
(white wires) and/or overload (black wire).
3. Install the new overload (Fig. 7) onto the top pin of the compressor (Fig. 8) and push the new relay (Fig. 9) onto the two bottom
pins below the overload (Fig.10). Reconnect the white wires onto the relay and the black wire onto the overload (Fig. 11).
Fig. 1 Fig. 2
Fig. 3
Fig. 5
Fig. 8
Fig. 10 Fig. 7
Fig. 9
Fig. 11
Overload and/or Relay Replacement