Crystal Mountain Storm Cafe, Руководство по обслуживанию, Страница: 22 / 37

22
4. Remove the wires connected to the thermostat and limiter (Fig. 13). Remove the ground wire from the hot tank. Locate the two
terminals at the bottom of hot tank and disconnect the wires from the Hot Tank Element. Disconnect the NTC sensor wires
(coming from top of hot tank) from the circuit board (Fig. 14).
Note: The wires may be difficult to remove from the spade connectors.
5. While holding the hot tank with one hand, remove the 3 screws from the top shelf (Fig. 15).
6. Remove the hot tank from cooler (Fig. 16).
7. While holding the new hot tank with one hand, align both tubes with the corresponding holes (Fig. 17 and 18).
Tighten the three screws to attach the hot tank properly.
8. Reconnect all wires as identified, if necessary, refer to the wiring diagram. Reinstall, the coffee module base, the steam valve,
pod holder base and the pod holder (Make sure that the silicone seal is installed correctly on the steam valve). Reinstall the
SmartFlo
™
and turn the blue locking clips in place to secure. Close and latch the locking arm. Close the top of the cooler and
re - install the upper rear panel.
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
①
②
Fig. 18
②
①