Crystal Mountain Storm Cafe, Руководство по обслуживанию, Страница: 20 / 37

20
Notice:
The information and/or procedures presented in the following demonstration(s) should be performed by a trained Water Cooler
Service Technician only.
Never attempt to service or repair a water cooler while it is plugged into any power supply.
Prior to any service or repair of the water cooler, ensure that the water has been completely drained from the system.
Note: Begin with the unit unplugged, the water drained, and the upper back panel removed.
Tip: Use a plier or flathead screwdriver to pry wire connecters off (Fig. 1).
1. Remove the wire terminals from the thermostat or limiter and identify.
2. Remove the two screws. Remove the thermostat (or limiter) from its bracket (Fig. 2).
3. There is enough heat transfer paste on the tank and old control to simply wipe the bottom of the new con-
trol against the old one (Fig. 3). Place into position and evenly tighten the two screws.
4. Reconnect the wires onto the thermostat (or limiter) as identified.
Fig. 3
Fig. 2
Fig. 1
Thermostat and/or Limiter Replacement