Cruisers Yachts 520 Express Series, Руководство пользователя

Страница: 108 / 140

8-4
520 Express Series
520 Express Series
CHECK SEACOCKS FOR LEAKS
1. Check the following seacocks:
a. Port and starboard engine cooling
water seacocks located in the engine
compartment.
b. Generator cooling water seacock
located in the engine compartment.
c. Air conditioning seacock located in
the engine compartment.
d. Head outlet seacocks located in the
port generator compartment and in
the port engine compartment.
2. Inspect hose connections at seacock for
leaks.

CAUTION
When replacing hoses, make sure
that the appropriate seacocks are
closed.
If hose is leaking, tighten hose clamp. If
hose is damaged, replace the hose and
clamps. See your Cruisers Yachts Dealer
for parts and service.
3. Inspect seacocks for signs of leakage at
base and handle.

CAUTION
Seacocks can only be replaced
when the yacht is out of the water.
If leakage is apparent, take your yacht to a
Cruisers Yachts Dealer for immediate
service.
CHECK PROPELLER SHAFT LOG
FOR WATER ENTRY
1. Operate yacht at cruising speed.
2. Inspect propeller shaft at shaft log. This
is a “dripless” shaft log, so no water
entry is permitted.

CAUTION
Cruisers Yachts will not warrant
damage incurred due to an
improperly adjusted or neglected
shaft log. Excessive water entry
could result in the submergence of
the engine compartment.
3. If water entry is apparent, adjust shaft
log.

CAUTION
Always hand tighten the shaft log
hose clamps. Tightening clamps too
tight will damage the packing
material and the shaft, ultimately
leading to system failure.
4. Check the rubber coupling. It should be
watertight. If leakage is apparent, tighten
hose clamps. If hose is damaged, or the
leak persists, refer the problem to your
Cruisers Yachts Dealer.
HOSE
CONNECTION
POINT
CHECK
FOR
LEAKS
CHECK
FOR
LEAKS
CSR162-13A
SHAFT LOG
HOSE
HULL
STRONG
SEAL
CSR173-16
Downloaded
from
Cruisers
Owners
Forum
http://www.CruisersOwnersForum.com