4-21
350 Express Series
Basic Systems Operation
OPERATION OF AC SYSTEMS
Connecting Shore Power Cable:
1. Make sure the shore dockside breaker, the yacht main dockside
breaker and the yacht AC/DC panel DOCKSIDE breakers are in
the OFF position.
2. Connect the shore power cable to the yacht receptacle and then
connect the shore power cable to the dockside power source.
3. Be sure the DC MAIN circuit breaker is off and any 120V AC or
240V AC breakers that should not receive power immediately are
switched off. If the indicator lights are normal, then the
DOCKSIDE 240/120V AC circuit breaker may be switched on. AC
and DC circuit breakers may then be switched on as needed.
4. Switch the shore dockside breaker to ON position. Switch the
yacht dockside power breaker to ON position. Check the AC/DC
panel POWER SOURCE AVAILABLE indicator lights. The 120V
AC LINE 1, V AC DOCKSIDE and 120V AC LINE 2 indicator lights
should be on. The REVERSED POLARITY light should be off.
Disconnecting Shore Dockside Power:
Switch the yacht DOCKSIDE 240/120V AC circuit breaker off. Switch
the yacht dockside power circuit breaker off. Switch the shore
dockside power circuit breaker off. The dockside power cable may
then be disconnected.
CAUTION
DO NOT turn the DOCKSIDE 240/120V AC breaker on if
the REVERSED POLARITY light is on. Severe damage
to the electrical system could result. Disconnect the
cable and have the fault corrected by a qualified
electrician.
Downloaded
from
CruisersOwnersForum
http://www.CruisersOwnersForum.com
