Page 45
DISARMED UNDER DURESS 4 + 2 CODE
This address is used to set the 4 + 2 code that will transmitted if the alarm system is disarmed under duress.
P580E Duress Alarm 4 + 2 Code -
2 Digit Number (Default = 84)
PROGRAMMING VOICE BOARD MESSAGES
This block of addresses (P251E - P258E) are used to select a voice message that a Zone will transmit in an alarm.
For this option to work the optional Voice Board Must be fitted. If a value of “0” or the “Bypass” button is entered at
any of these addresses then the zone will not report via the Dialer in either
Voice or Domestic
modes.
P251E Zone 1 Voice Message Number -
(Default = 1) Value= 0-99
P252E Zone 2 Voice Message Number -
(Default = 1)
P253E Zone 3 Voice Message Number -
(Default = 1)
P254E Zone 4 Voice Message Number - (
Default = 1)
P255E Zone 5 Voice Message Number -
(Default = 1)
P256E Zone 6 Voice Message Number -
(Default = 1)
P257E Zone 7 Voice Message Number -
(Default = 1)
P258E Zone 8 Voice Message Number - (
Default = 1)
MISCELLANEOUS VOICE BOARD MESSAGES
This block of addresses (P259E - P262E) are used to select a voice message that various Alarms will transmit via the
dialer. For this option to work the optional Voice Board Must be fitted. If a value of “0” or the “Bypass” button is
entered at any of these addresses then the alarm will not report via the Dialer in either
Voice or Domestic
modes.
P259E Panic Alarm Voice Message Number -
(Default = 1) Value= 0-99
P260E Fire Alarm Voice Message Number -
(Default = 1)
P261E Medical Alarm Voice Message Number -
(Default = 1)
P262E Battery Low Voice Message Number - (
Default = 1)
START MESSAGE NUMBER FOR DTMF CONTROL
This address (P250E) sets the start message for the DTMF remote control messages. The remote control messages
are set in a fixed sequence (refer to the addendum sheet supplied with the 90 second voice board for this list). If the
voice board is being used to indicate alarms using voice messages and DTMF remote control is also being used, the
alarm messages must be recorded first. When all alarm messages have been recorded you can then record the
remote control messages eg if you have 9 alarm messages recorded before the remote control messages, the value
entered at this address must be 10. A value other than “0” must be entered at this address for the function to work.
P250E Start of DTMF Remote Control Messages -
(Default = 0) Value= 0-99
DTMF REMOTE CONTROL CODES
This block of addresses (P334E - P337E) are used to program the 4 digit DTMF Remote Control Codes. These
codes allow a valid user to set or unset the alarm, turn outputs On or Off or enable the microphone input from a
remote telephone. Please refer to the User Operating guide or the addendum sheet supplied with the voice board for
the full operational sequence.
P334E Remote Control Code for Area “A” -
(Default = 0)
P335E Remote Control Code for Area “B” -
(Default = 0)
P336E Remote Control Code for Output Control -
(Default = 0)
P337E Remote Control Code to Enable the Microphone Input -
(Default = 0)
Zone 4 Msg No
1
Medic Msg No
1
Start of Msgs
0
DTMF control A
0
