Page 34
P623E Restore all Program Addresses from 200-399 to Default
P624E Restore all Program Addresses from 500-599 to Default
P625E Restore all Radio & Pendant codes to Default
CLEAR ALARM MEMORY BUFFER
This address (P626E) is used to clear the panels alarm memory buffer.
P626E
Clear Alarm Memory Buffer
WALK TEST MODE
This address (P627E) is used to enable walk-test mode while
in installer program mode. By pressing P627E at the keypad,
the keypad buzzer will beep at 1 second intervals to indicate
walk-test mode is active. By walking past all of the detectors
connected to the system and activating them, the associated
zone light will latch up at the keypad to allow verification that
all zones are working properly. By pressing the “Program”
or “Enter” buttons, walk-test mode can be terminated and
normal programming resumed.
All Walk test activities will go into the event memory for display via the LCD keypad or LED keypad ,
In memory display mode
P627E
Walk-test Mode
WRITE TO EEPROM (DTU) BOARD
This address (P628E) is used to copy the panels program configuration to an external EPROM memory card (DTU-
Data Transfer Unit) which can be plugged into the expansion socket on the control board.
P628E
Write to EEPROM (DTU) Board
READ FROM EEPROM (DTU) BOARD
This address (P629E) is used to return the panels program configuration from an external EPROM memory card
(DTU-Data Transfer Unit) which can be plugged into the expansion socket on the control board.
P629E
Read from EEPROM (DTU) Board
Reset Addr 21-199
Done
Clear Mem Buffer
Done
Walk Test Mode
- - - - - - - -
Read fromEEPROM
Write To EEPROM
Done
Done
