Crossfire 1000GTR, Руководство по обслуживанию

Страница: 182 / 266

- 68-
ENGINE
- 168 -
2). Installing the middle driven shaft
• uni ersal oint.
a. Install the opposite yoke into the uni ersal
oint.
. Apply wheel earing grease to the earings.
c. Install the bearing
onto the yoke.
CAUTION:
Check each bearing. The needles can easily
fall out of their races. Slide the yoke back
and forth on the bearings; the yoke will not
go all the way onto a bearing if a needle is
out of place.
a. Press each earing into the uni ersal oint
using a suita le socket.
NOTE
The bearing must be inserted far enough into
the universal joint so that the circlip can be
installed.
. Install the circlip
②
into the groo e of each
bearing.
ENGINE
- 169 -
1
、
CHECK
1). Checking the output shaft Y-1
• Dri e shaft coupling
• Output shaft
Pitting galling wear Replace.
• O ring
Damage Replace.
• earings
Pitting amage Replace.
2
、
MEASURE
• Output shaft swing
a. Temporary install the gearcase .
. rap a rag aroun a screw ri er
, and
then insert it into the installation hole
of the
right crankcase spee sensor to hol the
mi le ri en gear.
c. Attach the gear lash measurement tool
an ial gauge
.
a . mm . in
. Measure the gear lash while rotating the
output shaft ack an forth.
NOTE
Measure the gear lash at 4 positions. Rotate
the middle driven gear 90° each time.
3
、
INSTALL
• earing retainer
①
a. Place a rag
②
in the ise.
. ecure the earing housing e ge in the ise.
c. Attach the earing retainer wrench
③
.
. Tighten the earing retainer.
CAUTION:
The middle driven shaft bearing retainer has
left-handed threads. To tighten the retainer,
turn it counterclockwise.