Crossfire 1000GTR, Руководство по обслуживанию, Страница: 116 / 266

- 2-
MAINTENCE AND ADJUSTMENT OF THE UTV
- 102 -
b. Turn brake rod in or out until the correct free
play is obtained.
Turning in Free play is increased.
Turning out Free play is decreased.
c. Tighten the locknut to specification.
Locknut
17 Nm (1.7 m · kg, 12 ft · lb)
NOTE
Make sure that there is no brake drag on the
front or rear wheels.
CHECKING THE BRAKE FLUID LEVEL
1. Place the vehicle on a level surface.
NOTE
When checking the brake fluid level, make sure
that the top of the brake fluid reservoir top is
horizontal.
2. Lift the hood up.
3. Check:
brake fluid level Fluid level is under “MIN”
①
line Fill up.
NOTE
Brake fluid may erode painted surfaces or
plastic parts. Always clean up spilled fluid
immediately.
WARNING
Use only the designed quality brake fluid:
otherwise, the rubber seals may deteriorate,
causing leakage and poor brake performance.
Refill with the same type of brake fluid: mixing
fluids may result in a harmful chemical
reaction and lead to poor performance.
Be careful that water does not enter the master
MAINTENCE AND ADJUSTMENT OF THE UTV
- 103 -
.
cylinder when refilling. Water will significantly
lower the boiling point of the fluid and may
result in a vapor lock.
4. Close the hood.
CHECKING THE FRONT BRAKE PADS
1. Remove:
front wheels
2. Check:
brake pads Wear indicator groove
a
almost
disappeared
Replace the brake pads as a set.
Refer to “FRONT AND REAR BRAKES” in
chapter 5.
Brake pad wear limit a
1.5 mm (0.06 in)
3. Operate the brake pedal.
4. Install:
front wheels
CHECKING THE REAR BRAKE PADS
1. Check:
brake pads
Wear indicator groove
a
almost disappeared
Replace the brake pads as a set.
Refer to “FRONT AND REAR BRAKES” in
chapter 5.
Brake pad wear limit a
1.5 mm (0.06 in)
3. Operate the brake pedal.
.