Cristofoli Autoclave Quadra 54, Руководство пользователя

Страница: 23 / 26

ATTENTION! For any replacement of parts, contact your local dealer or the authorized technical assistance office. It’s
strongly not recommended the replacement of any parts by non-qualified people. We have listed below the most
frequent problems and possible solutions the operator can try in his/her own office.
TROUBLESHOOTING
• No power ---------------------------------------------------------------------------
•The power cable of the autoclave is not properly connected to the
autoclave or to the outlet ---------------------------------------------------------
• The
Start key was not pressed for 2 seconds to turn the equipment
on ---------------------------------------------------------------------------------------
• The circuit breaker is not switched on ----------------------------------------
• Defective electronic circuit ----------------------------------------------------
• Check if there’s a power outage in your area/building;
• ; Connect the power cable properly
• Press and hold the Start key for 2 seconds, the display will show the
initial information (brand, model and software version);
• Switch on the circuit breaker located in the back of the autoclave
(Fig. 1, page 9)
• See “
How to Proceed when Service is Needed ” (Page 24).
THE AUTOCLAVE DOES NOT SWITCH ON
THE AUTOCLAVE PRESSURE GETS TOO HIGH, ACTIVATING THE SAFETY DEVICES
• Partial obstruction of the solenoid valve -----------------------------------
• Defective electronic circuit ----------------------------------------------------
• Obstruction of the hose connected to the external steam exit or
water inlet --------------------------------------------------------------------------
• See “ How to Proceed when Service is Needed ” (Page 24).
• Remove the hose connected to the external steam exit and clear
any obstruction.
ATTENTION! Never use a plastic hose. See
“ Installation Instructions ” topic “ Hydraulic Installation ” (Page 9).
• The operator connected the autoclave to the power source but
didn’t press the Start key -------------------------------------------------------
• Nothing happens when the Start key is pressed --------------------------
• ---------------------------------------- The heating element has burned out
• ------------------------------------------------------------ Defective thermostat
• ---------------------------------------------------- Defective electronic circuit
• Press the Start key after selecting the cycle on the Mode key;
• See “ How to Use the Autoclave Quadra 54 ” (Page 14);
• See “ How to Proceed when Service is Needed ” (Page 24).
THE AUTOCLAVE SWITCHES ON BUT DOES NOT HEAT UP
If the problem persists after the verification of all the items listed, contact your local dealer.
POSSIBLE CAUSES SOLUTION
POSSIBLE CAUSES SOLUTION
POSSIBLE CAUSES SOLUTION
22
CRISTÓFOLI
A U T O C L A V E S
I N S T R U C T I O N M A N U A L