Cristec BAT-MON-3.5, Руководство пользователя

Страница: 30 / 36

29
4.3 S
HUNT
- B
ATTERY
M
ODE
For proper operation of the battery management, the following data must be set during first connection:
Data Comment Range
Name This name is associated to a logo displayed on the main page Start Stb, Start port,
Starter, Aux, Bow,
House, House I, House II
Battery type The battery type shall be selected. Full charge detection, critical
state of charge and deep discharge levels are set according to
battery type. GEL, AGM, Open Lead,
Lithium
Nominal
capacity
1
The nominal capacity of the battery should only be adjusted
when the batteries are 100% charged. A long press on nominal
capacity field until BEEP sound allows the reset of the capacity to
100%. 1-9999Ah
Charge efficiency
factor (CEF)
1
Factory setting is 98%. The CEF is automatically adjusted by
battery management averaging over the last 4 cycles. 1-100%
Nominal voltage Set the rated voltage 12 or 24V of the battery group so that the
capacity calculation can be done properly. 12V/24V
Cycle depth
1
Factory setting set to 30%. 10-90%
Alarm capacity User capacity alarm level : factory setting to 50 %. This level has
no relation with Capacity Off Level field available into Relay
settings (see section 4.2.1). 1-100%
Peukert factor
1
Factory setting according to battery type. 1.00-1.50
Overvoltage
Level Overvoltage alarm threshold (+1). Factory setting for the alarm
threshold is 15.0 V. 0-32V
Shunt Serial number of the shunt, software and hardware version. -
Additional battery at terminal (+2)
Name 2 This name is associated to a logo displayed on the main page Start Stb, Start port,
Starter, Aux, Bow,
House, House I, House II
Battery 2
Overvoltage Overvoltage alarm threshold (+2). Factory setting for the alarm
threshold is 15.0 V. 0-32V
Battery 2
Undervoltage Undervoltage alarm thr2. Factory setting for the alarm
threshold is 11.5 V. 10-26V
1 See terms and definition in section 5.3