26
The LIN-Network page opens
automatically when a new shunt is detected (this page is also accessible in the menu - see
section 4.2). To add a new shunt, follow the 3 steps procedure detailed below:
Step 1 :
If more than one shunt is used, disconnect all shunts power supplies. Connect the supply of the main
Battery mode shunt only (In our case SN is 7029).
Step 2 :
Press the #1 button in order to assign ID #1 to shunt 7029. The shunt will shift to the ID #1 row. Select
NAME by pressing the name’s area.
If the installation only uses one shunt, the system is ready to use. If more than one shunt is used, please follow
step 3.
Step 3 :
Connect the supply of the next shunt. This shunt will appear in the bottom row. Press button #2 in
order to assign the ID. The shunt will shift to the selected row (bottom right picture). Select the NAME by
pressing the corresponding areas.
Repeat the process if a third shunt is used.
