Crestron C2N-DB12, Руководство по эксплуатации и установке

Страница: 10 / 36

Decorator Wall Panels Crestron C2N-DB6/8/12
6
•
Decorator Wall Panels: C2N-DB6/8/12 Operations & Installation Guide - DOC. 6154
Button Replacement
Replacing/changing the removable buttons in a Wall Panel is a simple
process. Refer to the illustrations on the previous page and the following
procedures.
1. If the wall panel is installed in an electrical box, remove the two
1-inch securing screws, carefully pull the wall panel from the
electrical box, and disconnect the Cresnet cable.
2. Remove the four screws that attach the divider, and remove the
divider.
CAUTION: The removable buttons fit snugly on the rubber membrane
and must be removed carefully to avoid pulling the membrane from the
unit. Once membrane is detached, you may be unable to reattach it.
3. While holding adjacent buttons in place, carefully pull the
button(s) to be replaced from the rubber membrane.
4. Carefully press the replacement button(s) in place, make sure
LED window(s) orientation is correct, and attach the divider
using the four screws removed in step 2.
5. If applicable, reinstall the wall panel in the electrical box.
Industry Compliance
As of the date of manufacture, the wall panels have been tested and found
to comply with specifications for CE marking and standards per EMC
and Radiocommunications Compliance Labelling (N11785).
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.