CPWR-AN26, Rev A, 08-2018
Copyright © 2018 Cree, Inc. All rights reserved.
The information in this document is subject to change without notice.
Cree and Zero Recovery are registered trademarks, and the Cree logo and C3M are trademarks, of Cree, Inc
CAUTION
DO NOT TOUCH THE BOARD WHEN IT IS ENERGIZED AND ALLOW THE BULK
CAPACITORS TO COMPLETELY DISCHARGE PRIOR TO HANDLING THE BOARD.
THERE CAN BE VERY HIGH VOLTAGES PRESENT ON THIS EVALUATION BOARD
WHEN CONNECTED TO AN ELECTRICAL SOURCE, AND SOME COMPONENTS ON
THIS BOARD CAN REACH TEMPERATURES ABOVE 50˚ CELSIUS. FURTHER,
THESE CONDITIONS WILL CONTINUE FOR A SHORT TIME AFTER THE
ELECTRICAL SOURCE IS DISCONNECTED UNTIL THE BULK CAPACITORS ARE
FULLY DISCHARGED.
Please ensure that appropriate safety procedures are followed when operating this
board, as any of the following can occur if you handle or use this board without
following proper safety precautions:
● Death
● Serious injury
● Electrocution
● Electrical shock
● Electrical burns
● Severe heat burns
You must read this document in its entirety before operating this board. It is not necessary
for you to touch the board while it is energized. All test and measurement probes or
attachments must be attached before the board is energized. You must never leave this
board unattended or handle it when energized, and you must always ensure that all bulk
capacitors have completely discharged prior to handling the board. Do not change the
devices to be tested until the board is disconnected from the electrical source and the
bulk capacitors have fully discharged.
