CPWR-AN26, Rev A, 08-2018
Copyright © 2018 Cree, Inc. All rights reserved.
The information in this document is subject to change without notice.
Cree and Zero Recovery are registered trademarks, and the Cree logo and C3M are trademarks, of Cree, Inc
Some of the features
of Cree’s
CRD-06600FF10N reference design board are given below:
•
Isolated 250 VDC
–
450 VDC output
•
Maximum output current limited to 20 A
•
Maximum output power limited to 6.6 kW (AC/DC mode)
•
Maximum power at 250 VDC output limited to 5 kW.
•
Power is limited to 3.3 kW in case of DC/AC mode.
•
Universal input voltage range.
•
Full load THD < 5%.
•
Peak efficiency > 96%.
•
Firmware controlled input under voltage/over voltage protection
•
Firmware controlled output overvoltage protection.
•
Input overcurrent and output overcurrent protection.
•
LEDs for various fault indications on the control board.
•
Toggle switch ON control board for choosing AC/DC or DC/AC mode.
•
Potentiometer ON control board to set output voltage in case of AC/DC mode
and grid current in case of DC/AC (grid connected) mode.
