© Copyright 2005, Creative Playthings
WILLIAMSBURG WITH TENT ROOF
19687-100 Rev U (09-20)
Page 16
ASSEMBLY INSTRUCTIONS
STEP 21 — Front Wall Slats:
Fasten three Wall Slats (V) to the front platform end and the front
end tent support, as shown. Use four #10 x 1-5/8" screws in each
slat. Leave approximately 2-1/2" between each wall slat. The bot-
tom of all wall slats should be spaced approximately 1/2" above
the platform surface.
Parts have been omitted from the illustration for clarity.
Hint: Use the Slide Mount (K) to make sure there is enough room
for the slide.
STEP 22 — Rear Wall Slats:
Fasten six Wall Slats (V) to the rear platform end and the rear
end tent support, as shown. Use four #10 x 1-5/8" screws in each
wall slat.
Leave approximately 2-1/2" between each wall slat, except in
the center where there may be a conflict with the tent post. In
the center the gap will be 3-1/4"
Parts have been omitted from the illustration for clarity.
STEP 23 — Left Wall Slats:
Fasten six Wall Slats (V) to the left platform side and the left wall
support, as shown. Use four #10 x 1-5/8" screws in each wall slat.
Leave approximately 3-1/8" between each wall slat.
Parts have been omitted from the illustration for clarity.
V
The following steps include instructions for installing wall slats as shown on the cover of this guide. Plan the wall slat
positions according to your layout. In general, try to provide passage wider than 15" for any event. The opening for
a slide should be 24" or wider.
It is extremely important to never leave a gap of
more than 3-1/2" unless that gap is wider than 9".
A gap larger than 3-1/2" might allow a child's body to
slip through leaving the child's head trapped. A head
entrapment can be deadly.
V
V
#10 x 1-5/8"
Screws
#10 x 1-5/8"
Screws
#10 x 1-5/8"
Screws
1/2" gap
1/2" gap
1/2" gap
