© Copyright 2005, Creative Playthings
WILLIAMSBURG WITH TENT ROOF
19687-100 Rev U (09-20)
Page 10
ASSEMBLY INSTRUCTIONS
AA
Q
AA
STEP 3 — First Tower Side:
Raise one tower assembly on edge.
Secure one end of a Sandbox Side (T) to the corner post using
two 4" hex bolt assemblies. (Align the blind holes nearest to the
bottom of the posts).
Raise one side of the other assembly about
4-1/2 feet from the first and secure the next
end of the Sandbox Side to it in the same way.
Move to the middle of the posts and secure
one Platform Side (Q) using two 4" hex bolt as-
semblies, one at each end through the upper
hole only! Make sure the holes along the edge
of the board align closer to the bottom of the
posts.
Fron
t
Back
STEP 4 — Raise Tower, Install Ends:
Lift the top of the tower and settle the tower onto its base.
Mount the remaining Platform Side (Q) using two 4" hex bolt as-
semblies, one at each end through the upper hole only.
Finish the tower base by installing the second Sandbox Side (T)
Using four 5/16 x 4" hex bolt assemblies.
Q
Q
T
T
5/16 x 4" Hex
Bolts
Upper Hole
Only
Upper Hole
Only
Upper Hole
Only
5/16 x 4"
Hex Bolts
STEP 5 — Short Tent Pipes:
Slide one 56-1/2" Tent Pipe (AA) into the large hole in the front of the left
rear corner post. Slide the other end into the hole in the back of the left
front corner post.
You may need to loosen or remove one of the bolts holding the platform
side. Repeat with the other 56-1/2" Tent Pipe (AA) and the right corner
posts. Restore and tighten the bolts holding the platform sides.
