Crane Voce Media, Техническое руководство

Страница: 17 / 116

Technical Manual 9
Se
cti
o
n
2
- I
n
sta
lla
ti
o
n
A FRESH APPOACH TO VENDING
2.5 Setting Up the Carbonator Unit (If Applicable)
1. Open the cabinet door. Fit the seal (1),
provided in the installation kit, to the
regulator as shown in the photograph.
Connect the regulator to the CO
2
bottle.
2. Tighten the locknut. Carefully lift the CO
2
bottle into the machine ensuring that the
gas supply pipe is not trapped or obstructed
in any way.
Safety First! The CO
2
bottle may be heavy.
Always follow the correct procedure when
lifting heavy objects.
3. Secure the CO
2
bottle with the safety chain.
Turn on the supply from the bottle and
ensure that the regulator (2) is indicating a
pressure of 35 PSI.
4. Place the carbonator overflow pipe into
the waste bucket. Fill the carbonator water
bath with clean cold water until it starts to
flow from the overflow pipe.
5. Switch on the carbonator unit using the
Cold Unit switch located near the power
supply.
6. Place the syrup containers in the bottom
right-hand side of the cabinet and insert
the dip tubes into the containers ensuring
that the correct flavours correspond to the
drinks displayed on the display.
7. Prime the syrup selections ready for use by pressing button 13 on the service
keypad.
N.B. Ensure that the waste bucket is empty and in place before priming the
pumps.
8. To prime syrup pump 1, press and hold button 1 on the drink selection keypad until
the syrup appears from the dispense head. Repeat for syrup pump 2 by pressing
and holding button 2 on the drink selection keypad. Press the X (Exit) key to return
the machine to standby mode. Empty the waste bucket and refit to the machine.
9. Test vend the carbonated drinks to ensure correct operation of carbonator unit.
Check for leaks and ensure that the machine is left in a clean and safe condition.
Close the door.
N.B. If a still unit is fitted ensure that the ingredient timers for syrup drink 1 and 2 are
set to 6 seconds (recommended).
1
2