Crane Voce Media, Техническое руководство

Страница: 14 / 116

6 VOCE Media
Se
cti
o
n
2
- I
n
sta
lla
ti
o
n
3. Connect the flexi-hose supplied with your machine to the stopcock. Flush the
water supply before connecting the machine.
N.B. When connecting your machine to a water supply always use a new flexi-
hose. Never re-use an existing hose.
4. Connect the hose to the inlet located on the rear of your machine. Ensure that the
seal is correctly fitted. Ensure that all water supply fittings are tight.
5. Turn on the water supply at the stop tap and check for leaks.
2.3 Connecting the Electrical Supply
Safety First!
The electrical safety of this appliance can only be guaranteed if it is correctly earthed. The
manufacturer declines all liability for damage resulting from a system which has not been
earthed. On no account should it be earthed only to the water supply pipe.
The appliance must be connected to a mains supply with a capacity appropriate for the
application and in compliance with National and local regulations on electrical safety.
Important: If any internal fuses become damaged or fail in any way they must be
replaced by the correct fuse available from the manufacturer quoting the information
written on the label adjacent to the relevant fuse-holder.
Important: If the mains lead becomes damaged in any way it must be replaced by a lead
available from the manufacturer.
2.4 Installation Procedure
A trained installation engineer must carry out the following procedure before the
machine can be used for the first time. Ensure that the electrical and water services to the
machine are connected correctly. Check for leaks in the water supply.
1. Open the front door of your machine.
2. Ensure that the waste bucket is fitted correctly. Clip the level detector and
overflow pipes correctly onto the rim of the bucket.
3. Cup Turret. Remove the cup stack assembly from its packaging and carefully
place it onto the cup drop unit. Remove the lid and fill the tubes with the correct
size cups for the cup catcher type fitted to your machine. Allow the cups to drop
into the tubes directly from the packaging. DO NOT touch the cups with your
hands .
Important: Do not fill the tube directly above the cup dispense position. Allow
the cup turret motor to rotate a full tube to the cup dispense position when the
machine is powered up. Rotating the cup turret by hand will damage the
mechanism.