Crane Merchant Six 180, Руководство оператора

Страница: 29 / 210

Merchant™ Operators’ Guide Initial Setup
1810025 23 August 2009
Installing a Spiral Coupler (continued)
WHEN USED WITH A COUPLER BEARING
Hold the coupler bearing in place and push the spiral coupler through the bearing until the coupler
clicks into position. Be sure the coupler is in the proper orientation as shown.
Moving Trays Up or Down
This merchandiser can be adjusted to vend taller products. Some guidelines must be followed:
• Keep in mind that when you increase the product height available to a tray by lowering it, you
will be decreasing the product height available to the tray below.
• If a tray is in the lowest position, the tray below it should not be in the highest position.
• If a tray is in the highest position, the tray above it should not be in the lowest position.
• You will need to experiment with various tray positions to get the best results for your
products.
Proceed as follows:
1. Remove the tray from the merchandiser. (See “Removing Standard Trays” on page 13).
2. Remove the screw that secures the right tray guide rail to the front guide mounting channel as
shown.
3. Tap up on the guide rail and unseat the guide rail tabs from the channel slots.
4. Pull the guide rail away from the front and rear guide mounting channels.
5. Move the guide rail to the desired position.
6. Insert the guide rail tabs into the mounting channel slots as shown.
7. Tap down on the guide rail to seat the tabs in the channel slots.
8. Replace the screw that secures the guide rail to the front guide mounting channel.
9. Repeat steps 2 through 8 for the left guide rail.
10. Return the tray to the merchandiser. See “Installing Standard Trays in the Merchandiser” on
page 14
SPIRAL
COUPLER
SPIRAL
BEARING