19
TROUBLESHOOTING
WARNING
Before performing any type of maintenance/service, disengage all controls and stop the engine. Wait until all
moving parts have come to a complete stop. Disconnect spark plug wire and ground it against the engine to prevent
unintended starting. Always wear safety glasses during operation or while performing any adjustments or repairs.
Problem
Cause
Remedy
Engine Fails to start
1. Spark plug wire disconnected
2. Fuel tank empty or stale fuel
3. Throttle control lever (if equipped) not in
correct starting position
4. Choke not in ON position
5. Blocked fuel line
6. Faulty spark plug
7. Engine flooding
1. Connect wire to spark plug
2. Fill tank with clean, fresh gasoline
3. Move throttle lever to start position
4. Move lever to ON position
5. Clean fuel line
6. Clean, adjust gap, or replace
7. Wait a few minutes to restart, but do not
prime (if equipped)
Engine runs erratic
1. Spark plug wire loose
2. Unit running on CHOKE
3. Blocked fuel line or stale fuel
4. Vent plugged
5. Water or dirt in fuel system
6. Dirty air cleaner
7. Carburetor out of adjustment
1. Connect and tighten spark plug wire
2. Move choke lever to OFF
3. Clean fuel line; fill tank with clean, fresh
gasoline
4. Clear vent
5. Drain fuel tank. Refill with fresh fuel
6. Clean following engine manual
7. Refer to engine manual
Engine overheats
1. Engine oil level low
2. Dirty air filter
3. Air flow restricted
4. Carburetor not adjusted properly
1. Fill crankcase with proper oil
2. Clean air cleaner
3. Remove blower housing and clean
4. Refer to engine manual
Tines do not engage
1. Foreign object lodged in tines
2. Tine clevis pin(s) missing
3. Belt worn and/or stretched
4. Pulley and idler not in correct adjustment
1. Stop tiller completely, check and discard
foreign object
2. Replace tine clevis pin(s)
3. Replace belt
4. Take unit to authorized service