CRAFTOP NT3760, Руководство пользователя

Страница: 25 / 53

|
-22-
To reduce the risk of fire and burn injuries, start the
engine at least 10feet (3m) from the fueling spot,
outdoors only.
WARNING
To reduce the risk of injury from saw chain contact
and/or reactive forces, always engage the chain brake
before starting the chain saw.
WARNING
The saw chain has very sharp cutters and they will start
moving upon the engine starts. Touching them may
lead to severe personal injury. Avoid touching saw
chain whenever possible, and always wear gloves to
protect hands.
WARNING
To reduce the risk of serious or even fatal injury:
•
Never allow children or unauthorized persons access
to the machine.
•
Do not allow children or other unauthorized persons
to attempt to start or otherwise use the machine.
•
Never leave the machine unattended while working or
during work breaks.
•
After work, store the machine in a safe, secure
location out of the reach of children and other
unauthorized persons.
•
Observe safety precautions and instructions.
Pre-operation checklist
Follow the steps below before using the machine every
time:
1. Check and make sure you wear proper clothing and
PPE.
2. Check the starting location.
3. Keep children or other unauthorized persons well
away from work area where you plan to start the
machine.
4. Make sure that all the parts including saw chain and
guide bar are installed properly, and there is no
broken parts or lacks of any parts.
5. Check the fuel level to make sure there is sufficient
mixed fuel in the fuel tank.
6. Check the chain oil level to make sure it is located
at the proper position.
7. Check there is no leakage of fuel and oil.
8. Remove the chain guard (scabbard).
9. Make sure that the saw chain are not touching
ground or any other obstacles.
10. Double-check and observe all safety precautions
and instructions in this manual prior to starting the
machine.
WARNING
Do not use drop start. This method is very dangerous
because you may lose control of the chain saw, and
result in serious or even fatal injury.
Start cold engine
WARNING
When starting the engine, make sure that your body
does not contact with the muffler. A hot muffler can
cause serious burns.
1. If necessary, fill fuel into the fuel tank and tighten
the fuel cap securely; accordingly, you need fill
chain oil into the oil tank and tighten the oil cap
securely.
2. Disengage the chain brake by pulling the hand
guard towards the front handle.
3. Move the ignition switch to START position.
4. Pull out the choke knob, so as to leave the choke in
the CLOSE position.
5. Push down the throttle trigger lockout (A).
6. Open the throttle (B) fully.
7. Push the throttle latch (C) downwards.
8. Place the machine on a flat and firm ground in a
clear area. Make sure that the saw chain are not
touching ground or any other obstacles.
9. Hold the chain saw firmly on the ground with you
left hand on the front handle (your thumb should be
under the handle), put your right foot into the rear
handle and press down.
10. Grip the starter rope handle securely with your right
hand, pull it slowly until resistance is felt, then pull it
rapidly until start the engine.