|
-18-
The dust that occurs during chain
saw operation may be harmful to
health. Operators who are sensitive
to dust or other common airborne
allergens may need to wear a dust
mask.
After finishing your work
•
Always clean dust and dirt off the machine. Do not
use any grease solvents for this purpose.
•
Do not use a pressure washer to clean chain saw.
The solid jet of high pressure water may damage
parts of the machine.
Assembly
WARNING
Always shut off the engine and allow it cool down
before carrying out any work on the chain saw.
Always wear appropriate gloves
when handling the saw chain, in
order to protect your hands from
injury. The chain is sharp and can
cut you even when it is not moving!
If you received the chain saw in completely assembled
status, repeat all steps to ensure your chain saw is
properly assembled and all fasteners are secured.
Mounting guide bar and chain
1. Check that the chain brake is in disengaged
position by moving the front hand guard towards
the front handle.
2. Take off the bar nuts and remove the clutch cover
(chain brake). Take off the plastic shipping spacer
(if present).
3. Fit the bar over the bar bolts. Place the bar in its
rearmost position. Place the chain over the drive
sprocket and in the groove on the bar. Begin on the
top side of the bar. Make sure that the edges on the
cutting links are facing forward on the top side of
the bar.
4. Fit the clutch cover and locate the chain adjuster
pin in the hole on the bar. Check that the drive links
of the chain fit correctly on the drive sprocket and
that the chain is in the groove on the bar. Tighten
the bar nuts finger tight.
information
An adjusting pin and screw is used to adjust the tension
of the chain. It is very important when assembling the
bar that the pin located on the adjusting screw aligns
into a hole in the bar. Turning the screw will move the
adjustment pin up and down the screw. Locate this
adjustment before you begin mounting the bar onto the
saw. Illustration below shows the inside of chain brake,
and the arrow indicates the adjustment located on chain
brake.
5. Tension the chain by using the combination wrench.
Turn the chain adjuster screw clockwise. The chain
should be tensioned until it fits snugly on the
underside of the bar.
Содержание NT3760
Страница 5: ... 3 Product overview General overview ...
Страница 53: ...WWW CRAFTOP COM ...