page 7
8. Blade Assembly.
Time Saver
: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert
3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws/lock washers from
underside of motor. Align blade arm holes
with motor screw holes and attach blade arm
with blade arm screws/lock washers. Before
securing screws permanently, repeat with
remaining blade arms. Securely tighten all
screws.
Note:
Tighten blade arm screws twice a year.
blade arm screws/
lock washers
motor housing
blade arm
blade
blade attachment
screws and washers
9. Switch Housing Assembly.
Remove 4 screws from outer edge of switch
housing plate (
save screws for later use
).
Remove 1 screw from fitter plate on
underside of motor and partially loosen the
other 2 screws. Align slotted holes in center
of switch housing plate with loosened
screws in fitter plate, allowing male plug
from motor housing to come through hole
in middle of switch housing plate. Twist
switch housing plate to lock. Re-insert screw
that was removed and secure all screws.
NOTE: If you wish to use the fan with a light
kit (sold separately), please proceed to
Section 11; otherwise please continue with
the instrucitons in Section 9 on the
following page.
fitter plate
motor
housing
switch housing
plate
male plug
