11. Light Kit Assembly (Optional).
diagram d
motor housing
switch housing
hex nut
lock washer
finial
diagram a
diagram c
diagram b
molex
connections
BLACK
BLUE (or BLACK)
switch housing
male plug
female plug
light kit fitter
[
representative only
]
WHITE
WHITE
hex nut
lock washer
switch housing
plate
glass shade
[
representative only
]
bulb
[
representative only
]
WARNING
: Failure to disconnect power supply at
main panel prior to light kit assembly may result in
serious injury.
IF YOU WISH TO USE YOUR FAN WITH A LIGHT
KIT
(sold separately)
, remove finial from switch
housing. Next remove hex nut and lock washer
from top of light kit fitter. (Refer to
diagram a
.)
Gently push wires from light kit fitter (one by one)
through hole in middle of switch housing and
then screw switch housing onto threaded rod at
top of light kit fitter followed by lock washer and
hex nut that were previously removed. Tighten
hex nut over lock washer for a secure fit. (Refer to
diagram b
.)
Connect
WHITE
wire from light kit fitter to
WHITE
wire from switch housing. Connect
BLACK
wire from light kit fitter to
BLUE
(or
BLACK
) wire from switch housing. Be sure molex
connections snap together securely. (Refer to
diagram b
.)
Connect male plug from the motor housing to
female plug from switch housing, matching up
the colors on the male plug with the colors on the
female plug for correct fit. Be sure that the plugs
connect completely. (Refer to
diagram c
.)
Align holes in switch housing with holes in switch
housing plate. Re-insert the 4 screws that were
previously removed (page 7, Section 9) and
securely tighten all screws with a Phillips
screwdriver.
Attach glass shade(s) to light kit fitter using the
hardware provided with the light kit. (Refer to
diagram d
.)
NOTE
: If you are installing a bowl fixture, the
bulb(s) must be installed
first
.
Install bulb(s) specified by the light kit. (Refer to
diagram d
.)
If you are installing a halogen bulb, be
sure not to handle glass directly with your fingers as
oil from the skin may shorten the life of the bulb.
IMPORTANT
: When changing bulb(s), remember
to allow bulb(s) and glass shade(s) to cool before
touching.
light kit fitter
[
representative only
]
light kit
fitter
[
representative
only
]
switch housing
page 9
light kit fitter
[
representative only
]
