WARNING
: Turn off circuit breakers to current fixture from
breaker panel and be sure switch is turned to the OFF
position
CAUTION
:
Be sure outlet box is properly grounded and that
a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with Local Codes
or Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building
wires are different colors than those referred to in the
diagram to the right, please use a qualified electrician.
Pull extra wire slack from the upper end of the downrod.
When downrod is secured in place on the hanging
bracket, wire the receiver as follows:
Connect 3-wire plug from fan to 3-wire plug from remote
control receiver. Connect 2-wire plug from fan to 2-wire
plug from remote control receiver. Make sure plugs snap
together completely.
Connect
BLACK
wire from remote control receiver to
BLACK
wire from ceiling with wire connector provided.
Connect
WHITE
wire from remote control receiver to
WHITE
wire from ceiling with wire connector provided.
Connect all
GREEN
wires together (from fan and remote
control receiver) to
BARE
/
GREEN
wire from ceiling with
wire connector provided.
* Wrap each wire connector separately with electrical tape
as an extra safety measure.
Gently insert receiver (flat side up) into hanging bracket
and carefully push taped wire connectors into outlet box.
Let antenna rest outside of hanging bracket.
page 6
6. Wiring.
black (OUT to fan)
green/yellow
black
(AC IN from
breaker box)
black
(TO POWER supply)
outlet box
wall
control
(wiring for wall control)
plate
1
2
3 4
5
6
PLEASE NOTE
:
Wall and/or remote conrol must be used
for fan to operate. If you do not wish to use the wall
control, please proceed to Section 7 to continue with fan
installation.
IN ORDER TO WIRE WALL CONTROL
, remove existing
wall switch. Wire the
WALL CONTROL
with wire
connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires and
taped wire connectors into outlet box.
Install battery (included) in wall control.
IMPORTANT
: Wall control will not function unless
battery is installed.
WARNING
:
CONNECT WIRES IN THE FOLLOWING
ORDER ONLY!
Connect
GREEN/YELLOW
ground wire to ground from
house or directly to one of the screws from the outlet
box.
Connect one
BLACK
wire from wall control to
BLACK
(hot) lead wire from house. Connect second
BLACK
wire
from wall control to
BLACK
load wire to fan.
Attach wall control to outlet box and secure with screws
from original wall switch. Attach front plate to wall
control using 2 screws provided in the wall control.
green/
bare
ground
black
ground (green
or bare)
white supply wire
black supply wire
from receiver
black
AC IN L
AC IN N
white
white
ground (green
or bare)
antenna
from ceiling
receiver
black
green
*
(wiring for receiver)
3-wire plug
white
blue
yellow
brown
pink
from
receiver
from fan
2-wire plug
green
from fan
