page 4
5. Fan Assembly.
NOTE
: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
hanging ball
stop pin
set screw hole
hanging
ball
stop pin
diagram 2
diagram 1
diagram 4
diagram 3
canopy
motor
housing
yoke cover
canopy
cover
downrod
clip
downrod
electrical
wiring
safety
cable
yoke set
screw
and nut
pin
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging ball
and remove stop pin and then slide hanging ball off of
the downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing yoke.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
[
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack from
the upper end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--
make sure wires do not get twisted
. Re-insert pin
and clip that were previously removed. Tighten yoke set
screws and nuts securely.
[
Refer to
diagram 2
.
]
Locate canopy cover in hardware pack. Slide yoke cover,
canopy cover and canopy over downrod.
[
Refer to
diagram 3
.
]
(
Note
: Canopy cover must be turned with
shiny side
toward
the motor housing.)
Thread safety cable and wires through hanging ball;
then slide hanging ball over downrod--the top of the
downrod should be noted as having a set screw hole;
use this hole when setting the set screw. Insert stop pin
into top of downrod and raise hanging ball. Be sure stop
pin aligns with slots on the inside of the hanging ball.
Tighten set screw securely.
[
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw completely
could result in the fan becoming loose and possibly
falling.
["Fan Assembly" continued on next page.]
