page 9
CAUTION
:
The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable
receiver or fan.
This remote control transmitter is equipped with 16 code
combinations to prevent possible interference from or to
other remote units such as garage door openers, car alarms
or security systems. If you find that your fan and light go on
and off without using your remote control, simply change
the combination code in your remote control transmitter
(and wall control).
To set the code, perform these steps:
Remove battery cover on back side of remote control
transmitter.
Use a ballpoint pen or a small screwdriver to set the code
switches 1 through 4 for the transmitter.
Use the same
number sequence used when wiring the wall control in
Section 6 (page 6).
Note
: Since this fan comes with a halogen bulb, the
dimmer switch (labeled
D
and
X
) has been pre-set to the
"ON" position (
D
). If you do not wish to have dimming
capability, please move the switch to the "OFF" position
(
X
).
Install 9-volt battery (included) in transmitter and then
replace the battery cover.
IMPORTANT
: Store the transmitter away from excess
heat or humidity. To prevent damage to transmitter,
remove the battery if transmitter will not used for long
periods.
Restore electrical power and then set slider switch on wall
control to the ON position. Within 30 seconds of turning
on the wall control, press the "OFF" button, located on the
front of the transmitter, for 5 seconds or until light blinks
twice. Test the light and fan functions to confirm the
learning process is complete--see Section 13.
10. Automated Learning Process./
Activating Code.
dimmer
switch
dip
switches
TRANSMITTER
(front)
1
TRANSMITTER
(back)
battery
battery
cover
11. Wall Control Operation.
ON/OFF slider switch
- turns
wall control
ON or OFF
HI
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
FAN OFF
button - turns
fan
OFF
LIGHT
button - turns
light
ON/OFF when pressed
once; dims
light
when pressed and held down. Auto
resume capability keeps light at same brightness
level as the last time it was turned off.
