page 10
12. Remote Control Operation.
It is recommended that you test fan before finalizing
installation. Locate ON/OFF slider switch on wall
control and set to the ON position. Test light and
dimmer function and then test fan speeds. Next,
locate remote control transmitter. Test fan speeds
with the different fan speed buttons on remote
control. Test the light ON/OFF function with the
button on the remote control. Test dimmer function
by holding down the button for more than 2
seconds. (
diagram 1
) If the remote control operates
all of the functions of the fan and light, battery has
been installed correctly. If fan and/or light do (does)
not function, please refer to "Troubleshooting"
section to solve any issues.
Turn fan completely off
before
moving the reverse
switch (located on top of motor housing). Set reverse
switch to recirculate air depending on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your
comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for
fan to function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
NOTE
: If the remote control interferes with other
appliances, change code switches on the transmitter
(AND the wall controll) to another code. If you do
change the code,
turn power off first
, remove the
battery cover, and, after setting the new code, go
back to the instructions in the last paragraph of
Section 10 (page 9).
HI
button - turns fan to HIGH speed
MED
button
- turns fan to MEDIUM speed
LOW
button
- turns fan to LOW speed
OFF
button
- turns fan OFF
button - controls LIGHT function: turns light
ON/OFF when tapped quickly. Pressing and
holding button down for more than 0.7 seconds
converts it into a dimmer. Auto resume capability
keeps light at same brightness level as the last
time it was turned off.
reverse switch
13. Testing Your Fan.
diagram 1
diagram 2
diagram 3
diagram 4
motor
housing
(
topside
)
remote control
transmitter
wall
control
