page 9
9. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws.
Align slotted holes in fitter plate with
loosened screws in motor plate, allowing
molex connectors to come through center
hole in fitter plate. Twist fitter plate to lock.
Re-insert screw that was previously removed
and securely tighten all 3 screws with a
Phillips screwdriver. [
Refer to
diagram 1
.
]
Connect
WHITE
wire from motor housing to
WHITE
wire from the light kit and
BLUE
(or
BLACK
)
wire from motor housing to
BLACK
wire from light kit. Make sure molex
connections snap together completely.
Remove screws from 3 posts located on
underside of fitter plate. Carefully arrange
wiring within the back of light kit. Align
holes in light kit with posts in fitter plate.
Re-insert screws previously removed and
securely tighten all 3 screws with a
Phillips screwdriver. [
Refer to
diagram 2
.
]
Install three 6 watt medium base LED bulbs
(included).
IMPORTANT
: When replacing bulbs, allow
bulbs and glass shade to cool down before
touching.
Align grooves on glass shade with nodules
on inside edge of light kit and push up
gently on glass shade. Twist shade to the
RIGHT (clockwise) until glass shade locks into
place.
Pull down VERY GENTLY on shade to make sure
that shade is secure.
[
Refer to
diagram 3
.
]
diagram 1
diagram 3
fitter plate
fitter plate
light kit
post
LED bulb
grooves
nodule
glass shade
screw
motor plate
motor
housing
diagram 2
molex connections
screw
molex
connections
light kit
