page 8
9. Light Kit Assembly (Optional). (cont.)
Punch center cap out of switch housing cap with a
screwdriver. Remove the hex nut and lock washer from
threaded rod at top of light kit fitter. Feed wires from
light kit fitter through center hole in switch housing
cap. Then, screw switch housing cap onto threaded rod
on light kit fitter followed by lock washer and hex nut.
Tighten hex nut over lock washer for a secure fit.
Hg
LAMP CONTAINS MERCURY
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010
Connect
WHITE
wire from switch housing plate to
WHITE
wire from light kit fitter. Connect
BLUE
(or
BLACK
) wire from switch housing plate to
BLACK
wire from light kit fitter. Be sure molex connections
snap together securely.
Align holes in switch housing cap with holes in
switch housing plate. Attach light kit fitter to switch
housing plate with 3 screws that were previously
removed. Secure all 3 screws with Phillips
screwdriver.
Install 2 medium base 13 watt compact fluorescent
bulbs (included).
Important
: When replacing bulbs, please allow bulbs
and glass shade to cool down before touching.
Remove finial, finial plate and threaded washer from
bottom of light kit fitter.
Raise glass shade and align threaded rod on light kit
fitter with hole in middle of glass shade and push up
gently allowing threaded rod to come through hole.
Secure glass shade with threaded washer.
Note
:
Do
NOT overtighten threaded washer as glass may crack or
break.
Align hole in center of finial plate with threaded rod
and push up. Attach finial.
Note
:
Do NOT overtighten
finial as glass may crack or break.
hex nut
lock washer
switch housing
cap
hex nut
lock washer
center
cap
light kit
fitter
molex
connections
light kit fitter
switch
housing cap
finial
finial plate
threaded
rod
threaded washer
motor
housing
switch
housing
plate
glass shade
bulb
