page 7
8. Blade Assembly.
Time Saver:
Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware packs. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws (along
with washers) with fingers first and then tighten
screws securely with a Phillips screwdriver. Repeat
procedure for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (
save blade arm screws and lock washers
to secure blade arms
). Align blade arm holes with
motor screw holes and attach blade arm with lock
washers and blade arm screws. Before securing
screws permanently, repeat this procedure with
remaining blade arms. Securely tighten all screws.
Important
: Tighten blade arm screws twice a year.
9. Light Kit Assembly (Optional).
motor housing
plastic
motor
lock
switch
housing
plate
blade arm
blade arm
screws
lock washers
Remove 1 screw from fitter plate (on underside of
motor) and partially loosen the other 2 screws.
Align slotted holes in switch housing plate with
loosened screws in fitter plate, allowing molex
connections from motor housing to come through
hole in middle of switch housing plate. Twist
switch housing plate to lock. Re-insert screw that
was previously removed and tighten all 3 screws
securely.
Remove 3 screws from outer edge of switch
housing plate.
If you wish to use fan WITHOUT light kit
, align
holes on rim of switch housing cap with holes in
switch housing plate. Re-insert screws that were
previously removed and securely tighten all 3
screws with a Phillips screwdriver.
Please proceed
to Section 10 on Page 9 to complete installation
without light kit.
If you wish to use fan WITH the light kit,
continue
with Section 9 on the following page.
motor
housing
fitter plate
switch
housing
plate
molex
connections
switch housing cap
