Crafco SUPER SHOT 125, Инструкция по эксплуатации и запасным частям

Страница: 33 / 230

Super Shot 125 Diesel Melter Part Manual
Chapter 5 Operating Instructions
©2017 by Crafco, Inc. All Rights Reserved………………..…………………………………..….Operating Instructions 5-5
5.3 Machine Start Up for 47400
Step Action
1 Fully open the exhaust stack cover.
2 Turn the key to the “ON” position. Allow engine controller to boot up.
2a To start engine, press “Auto” then “RUN”. Engine will preheat then start. The engine will
start and run at 1000 RPM for 30 seconds, then the RPM will increase to medium RPM.
When the material temperature reaches 275°F (135°C) or the compressor toggle switch is
turned “ON” the RPM will increase to high RPM which is full throttle.
3 Turn the “BURNER” toggle switch in the control box to the “ON” position. The red light
marked “BURNER” will illuminate indicating that the material and hot oil temperatures are
below set point. When the red light goes off this indicates the material or oil temperatures
are up to the set point.
Note: Just because this light is illuminated does not indicate the burner is actually
working.
4 Set the heat transfer oil temperature at 500°F (260°C).
5 Set the material temperature to the manufacturer’s recommended temperature.
CAUTION
If the burner fails ignition after 3 attempts the “BURNER LOCKOUT” alarm will sound. To
reset burner, hold the “RESET” toggle switch in the “DOWN” position for 5 seconds,
then release. The burner should ignite. If the burner still does not ignite, refer to
8.1.1
Symptoms: Burner will Not Ignite
to determine the malfunction.
Important: The solid material in the tank melts first around the walls, and bottom. The
material temperature sensor is located by the wall, therefore, it is possible that at the
beginning of the melting process the indicated temperature reaches operating
temperature, but the material in the center of the tank is still solid. This is normal, and
when the heated hose is ready for operation, most of the material in the tank will be
melted and heated to the proper application temperature.
6 Allow the heat transfer oil to continue to heat.
7 When the material reaches 275°F (135°C), the mixer light will illuminate which indicates
the mixer can be engaged by turning the toggle switch at the control panel to
“FORWARD” position. If the mixer does not move, allow the material to heat longer.
Note: Mixer speed is preset at the factory and cannot be adjusted. The mixer cannot be
engaged until the material reaches 275°F (135°C).
CAUTION
Jamming the mixer can cause the hydraulic oil to overheat and damage the machine.
8 The hose automatically turns “ON” when the material temperature reaches 275°F
(135°C). The red light marked ‘HEATED HOSE” will illuminate when the hose control is
calling for heat.
Table 5-4 Starting the Burner for Electric Compressor