Crafco SUPER SHOT 125, Инструкция по эксплуатации и запасным частям

Страница: 46 / 230

Super Shot 125 Diesel Melter Part Manual
Chapter 5 Operating Instructions
©2017 by Crafco, Inc. All Rights Reserved………………..…………………………………..….Operating Instructions 5-18
5.16 Shot Timer Option
This option is used to place marker adhesive on the road surface for raised reflective markers. This
option will allow you to place the same shot size of material each time you pull the wand trigger.
The steps listed below will tell you how to operate the shot timer option.
Step Action
WARNING
Put on protective clothing, gloves, hard-soled shoes, and face shield or safety glasses
when operating or filling this machine. Read the entire manual before operating the
machine.
Never point the wand at any part of your body or at any other person. Hot materials
can cause severe burns.
Important: Some difficulty may be encountered when starting up on cold days.
Although the wand is designed to heat the material all the way down to the tip,
on cold days you can place the tip of the wand into the shoebox to facilitate
material melting in the valve. Insert the wand tip for only a short time before
proceeding.
1 Allow the material to reach 380°F (139.3°C) and the hose to reach 380°F
(139.3°C); or proper operating temperatures.
2 Make sure the toggle switch inside the main control box labeled “PUMP” is
toward the “CRACK SEAL”.
3 Turn the pump speed control to the lowest setting by turning the speed control
knob fully clockwise.
4 With the wand tip inserted in the shoebox on top of the melter, depress the
trigger on the wand and slowly increase the pump speed by turning the speed
control knob counterclockwise until the pump motor starts to turn and material
flows from the tip of the duckbill valve.
5 Once the material is flowing properly release the wand trigger and change the
toggle switch labeled “PUMP” to “Marker”.
Table 5-15 Shot Timer Option