Crafco E-Z 50, Инструкция по эксплуатации и запасным частям

Страница: 22 / 37

E-Z 50 Melter Part Manual
Maintenance Instructions Chapter 6
©2017 by Crafco, Inc. All Rights Reserved…………………...………………………..……………Maintenance Instructions 6-2
6.5 Tongue Jack
Lubricate the tongue jack, using a good grade of bearing grease.
6.6 Temperature Control Calibration
Check the control knob calibration weekly. Calibrate by setting temperature dial to 200°F. When
the burner shuts off, indicated by the green light turning off, carefully pull the knob (See
Figure 6.3 )
off the stem. Be careful not to move the stem during this operation. With a jeweler’s screwdriver
turn the adjusting screw (See
Figure 6.2 ) inside the stem counterclockwise to increase temperature
or clockwise to decrease temperature (1/8 turn will change the temperature 150°F – 200°F),
carefully replace knob. Both the knob and the temperature gauge should now read approximately
200°F.
6.7 Maintenance Chart
Table 6-1 Maintenance Chart
Hours
Possible Cause Procedure 8 20 250 500
Engine check oil level
Refer to the manufacturer’s
instructions for the engine
X
Heat Transfer Oil
Check X
Change X
Hydraulic Oil
Check X
Change X
Burner Clean burner Once a year
Wheel Bearings
Clean and re-pack using a
good grade of bearing
grease
Every 24,000 miles or
two years
Tongue Jack
Grease using a good grade
of bearing grease.
Once a year
Knob
Adjusting
Screw
Stem
Figure 6.3
Figure 6.2