Crafco E-Z 50, Инструкция по эксплуатации и запасным частям

Страница: 10 / 37

E-Z 50 Melter Part Manual
Safety Chapter 2
©2017 by Crafco, Inc. All Rights Reserved………………………………………………...……………………………...Safety 2-2
2.3 Equipment or Operational Safety Continued
•
Calibrate the temperature control operation after each 50 hours of machine operation. Refer to
Chapter 6, Maintenance Instructions.
•
Replace any hoses which show signs of wear, fraying or splitting.
•
Make sure all fittings and joints are tight and do not leak each time the machine is used.
•
Do not leave the machine unattended while the burner is lit.
•
Tighten all bolts and screws every 100 hours of machine operation.
2.4 Safety Symbols and Notices
Important safety symbols and notices are marked on the machine and in this manual. Failure to
comply could result in equipment damage, operational malfunction, serious injury, or death. Please
read and comply with all symbols and notices. The table below includes the most commonly used
symbols and notices.
Table 2-1 Safety Symbols and Notices
Symbol Item Remarks
WARNING
Warning
Refers to possible bodily injury or death.
CAUTION Caution
Refers to possible equipment damage or operational
malfunction.
Severe Burn Hazard
Hot material can cause severe burns.
Protective Shoes
Wear hard-soled work shoes.
Protective Gloves
Wear heat resistant gloves.
Protective Face or Eye Wear
Wear face shield or safety glasses.
Body Crush Hazard
Do not stand between trailer and hitch when hooking
melter to truck.