CPI S4UIA, Инструкция по установке и эксплуатации

Страница: 50 / 92

O
PERATION
5-8
D
OC
.01040086 R
EV
.7
5.3.4 Main Control Keys
The main control keys are defined in Table 5-3. They are used to control the basic function of the
Indoor SSPA.
Table 5-3. Main Control Keys and Function
Key Description
TRANSMIT If the control point is local, a transmit command will be sent
to the SSPA. In remote mode this key will bring up the
SETUP (1/5) where the user can set amplifier in local mode.
STANDBY If the control point is local, a standby command will be sent
to the SSPA. In remote mode this key will bring up the
SETUP (1/5) where the user can set amplifier in local mode.
RESET Resets the fault state of the Amplifier. In remote mode this
key will bring up the SETUP (1/5) where the user can set
amplifier in local mode.
5.3.5 Menu Key
Press MENU and use the directional keys to scroll through menus. To enter a menu use the
ENTER key. The EVENT LOG, SETUP, CALIBRATION, TRIP POINTS, SCREEN CFG,
VERSION, SWITCH, TIME, and IP SETUP may be changed or viewed or saved in the menu
screens by using the directional keys and enter key. To return to the main screen press MENU.
Figure 5-6 is a screen shot of the menu.
Figure 5-6. MENU Display
5.3.5.1 Event Log
The event log can hold up to 2000 events in battery backed SRAM. After the log is full, the
oldest record will be overwritten by the newest event.
Each event logged stores the event trigger type, current operating mode, the time and date
stamp, and the following meter readings: RF Power Out, Reflected RF Power, Attenuation
Setting, Brick Hot Spot Temperature, Drain Current, Drain Voltage and Fan Speed Setting, Fan
Speed, Inlet Air Temperature, PSU Fet Temperature and PSU Diode temperature.