Cosen SVT-6070H, Инструкция по эксплуатации

Страница: 58 / 106

4-22
CUTTING OPERATION
Step 1 – Check before you cut

Power:
Check the voltage and frequency of your power source.

Coolant:
Check if you have sufficient coolant in the tank.

Hydraulic:
Check if you have sufficient (at least two-thirds or higher) hydraulic oil.

Workbed:
Check if there is any object on the feeding bed that may cause interference.

Blade:
Check the blade teeth and make sure there is no worn out teeth along the blade.

Light:
Check the work lamp or laser light (optional) and make sure there is sufficient lighting.

Movable workbed:
Check the workbed to see if it can be moved to the right and left smoothly.
Step 2 – Place your workpiece onto the workbed by using a lifting tool e.g. a crane.
Before loading, make sure the movable workbed is moved to the right to allow enough
clearance for the workpiece. When loading, take extra care not to have the workpiece bump into the
blade.
Step 3 – Position your workpiece.
Step 4 - Clamp the workpiece top-down and sideways if necessary.
Step 5 – Turn the
cutting pressure control
knob to adjust blade cutting pressure according to the
material.
Step 6 - Adjust
workbed feed speed control
knob to obtain a suitable blade feed speed for your
material.
Step 7 – Start running the blade.
Before you start cutting, check again that there is no other object in the cutting area.
Step 8 – While the movable workbed approaches the material, adjust the blade speed if necessary.
You can do so by pressing the
blade speed adjusting
buttons in the HMI touch screen. The
blade speed is also displayed in the HMI touch screen.
Step 9 – Select the proper cutting condition according to different material.
Step 10 – After the entire cutting job is completed, move the workbed to the right to its starting
position and unload the cutoff workpiece.
Step 11 – Clean the workbed by removing chips and cutting fluids.
Step 12 – Move the workbed to a proper position then turn off the power.