Cornwell Tools MIG 250MGS, Руководство пользователя

Страница: 24 / 28

Page of 28 24
TROUBLESHOOTING
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
Unit Does Not Power Up Unit Is Not Plugged In Plug In Unit
Input Power Circuit Breaker Not On Reset Input Power Circuit Breaker
The Main Power Switch Is Not Working Replace Main Power Switch
Protection Indicator Is On The internal temperature is too high. Leave power on and let the fan cool the
unit. Output will continue when the unit
has cooled.
Cooling Fan Is Damaged Replace the cooling fan.
Wire Drive Motor Does Not Turn Wire Feed Speed Control at Zero Increase Wire Feed Speed Control
Trigger Is Not Mashed Wire Will Feed Only When Trigger Is
Mashed
Wire Drive Motor Is Damaged Replace Wire Drive Motor
Feed Roller Is Not Correctly Installed See Installation section to correctly install
the drive roller.
Wire Feeds Inconsistently Torch Liner is plugged Clear or replace torch liner
Wire Diameter may vary on spool of wire
causing the wire to catch in the contact
tip. Increase the contact tip one size.
Too Much or Too Little Wire Tension See Installing The Wire Section
Too Much or Too Little Drive Roll Tension See Setting Drive Roll Tension Section
Drive Roll is Worn Replace Drive Roll
Can Not Create An Arc Work Piece is Painted Or Rusty Remove All Paint And Rust
Ground Clamp Is Connected Where
There Is Paint Or Rust Remove All Paint And Rust So Ground
Clamp Is Connected To Bare Metal
Ground Clamp Is Not Electrically
Connected To The Work Piece
Make Certain The Ground Clamp Is
Connected To The Work Piece
Trigger Is Not Mashed This Unit Is Not Electrically Hot Until You
Mash The Torch Trigger
Welding Arc is unstable, excessive
spatter. The contact tip is too large. Make certain the correct contact tip is
installed.
Torch Liner is plugged Clear or replace torch liner
No Shielding Gas Connect Shielding Gas Supply And Turn
Shielding Gas On.
MIG torch is not correctly installed and
shielding gas is not transferring to the
arc. Remove And Reconnect The MIG torch
To Make Certain It Is Completely Installed
Into The MIG Connector.
Wire Speed Setting Is Incorrect. Refer To The Label Inside The Wire
Compartment Door For Wire Speed
Setting Recommendations.
Voltage Setting Is Incorrect. Refer To The Label Inside The Wire
Compartment Door For Voltage Setting
Recommendations.
For Assistance, Contact The Welder Help Line At 888-762-4045