VCX-4402-E Installation and Operating Instructions
Page 7
Quick Start
If user wishes to configure settings with VCX4402-E via COM Port or Network:
Set up for COM Port:
User may configure VCX4402-E setting using a PC connected to the encoder
control port at the front of the unit. A simple 6-wire phone cable (PCA-2400
programming cable) with the
RJ-11 adaptor described in Appendix A
will supply the
proper RS-232 connection to the PC’s serial port.
Note:
This is not the same as the “Sub-
Channel” interface. Do not use the RJ-11 adaptor for this channel.
This configuration will permit the unit configuration by a terminal program running on a
PC. Once you have connected the encoder to the PC’s serial port open your terminal
program. The encoder will boot up then ask for a password. The default password is:
admin
.
The PC should have its Com Port configured as:
Baud rate
38,400 kbps
Data bits
8 bits
Parity
No Parity
Stop Bits
1 Stop Bit
Flow control None
Refer to Appendix A for pin layout for RJ-11 connector.
Set up for network:
If the operator wishes to configure the unit through the network the user may
accomplish this by the following procedure.
Note:
The operator must be sure that the
VCX-4402-E is accessible on their SUBNET.
Before completing this step, please refer
to the Programming Configuration Section of this Manual
. Here you will set the IP
address and SUBNET Mask of the VCX-4402-E so that it is accessible on your SUBNET
and has a valid IP address. (An example IP address is being used in the following
example.):
Open a “cmd” window and enter the following commands:
Telnet 192.168.0.253
<enter>
The encoder will reply asking for a password. Default password is “admin”.
Password:
admin
