VCX-4402-E Installation and Operating Instructions
Page 12
Connecting to Unit
There are currently five ways to connect to the VCX-4402-E.
1)
Telnet
Password: admin (default)
To change the default password perform the following:
Type:
PASSWORD
<followed by your password (up to 11 characters)>
Where <your password> equals the new password.
For configuration using an Ethernet connection, activate the Telnet function by the
following:
a.
Initiating from the Command Prompt - Telnet nnn.nnn.nnn.nnn
b.
Use the MS Windows – START – RUN Telnet nnn.nnn.nnn.nnn
(where nnn.nnn.nnn.nnn is the IP address of the unit being configured)
Employ the command set as described below.
Note that the initial IP addresses (factory default) are:
Encoder 192.168.0.253
Decoder 192.168.0.254
Sub net Mask 255.255.255.0
(Alternatively, the end user software SW-2400 is usable when an Ethernet connection is
established.)
