VCX-4402-E Installation and Operating Instructions
Page 10
IP Configuration
Overview
The commands contained in this section provide the means to configure critical network,
com ports, encoder, and decoder parameters. The user should consult the factory if specific
functions of interest do not appear to be supported.
Initial IP Addressing
To set the device parameters properly, encoder and decoder units must be given appropriate
IP addresses, compatible with the network on which they are to be connected. The software
module
VXNETCONFIG
was developed to allow a network administrator to set the IP and
Subnet in the VCX-4402 series encoders and decoders.
1)
Installation
To load VXNETCONFIG insert the CORE TEC CD into your CD drive. Select
VXNETCONFIG by double clicking on the program. The following window will open:
VCXNETCONFIG Window
