13
STEP 2: Choose a Location for Inverter Mounting
WARNING
: Fire and Explosion hazard –
It is possible for the inverter to produce arcs and/or sparks, do
not install or use inverter near flammable materials (i.e. gas-powered machines, fuel tanks, or any
components connecting to a fuel supply). Follow any instructions from the battery manufacturer being
used.
WARNING
: Fire hazard –
Ensure the ventilation openings are not covered or obstructed to reduce risk of
fire. Installing the inverter in a compact compartment will be detrimental and may result in overheating.
Location(s) must conform to these required parameters:
Dry:
Do not allow water or other fluids to splash or drip on to the inverter.
Cool:
Ambient, air temperature should be between 0°C and 50°C (32°F and 122°F).
Power linearly derates from 100% at 25°C to 70% at 50°C.
Ventilated:
Provide a minimum of 5 inches (13cm) of clearance at the DC end of
inverter for air flow. Also give at least 1inches (2.5cm) on each side, and 2 inches (5cm)
at the AC end. Do not allow ventilation to be obstructed.
Safe:
Do not install the inverter in the same compartment as flammable liquids,
batteries, or any unsafe materials.
Close-in:
Avoid excessive cable lengths, especially between inverter and battery banks.
Batteries:
Never allow battery acid to come in contact with the inverter or the wiring to
and from the devices. It is also important to be aware of the corrosive gases that may be
coming into contact with the inverter.
STEP 3: Mount the Inverter
To mount:
1.
Remove the inverter from packaging and check that all components are present.
2.
Select the mounting location (see illustration
Figure 1-3).
One of the following approved
orientations is required:
Under horizontal surface (1)
Horizontal position on vertical surface (2)
On horizontal surface (3)
3.
Using the inverter as a template, mark and drill pilot-holes for the desired mounting
location.
4.
Fasten the inverter to the mounting surface using pan-head wood or sheet metal screws
if mounting to a wall or bulkhead. Do not block vents on bottom of inverter.
