Product
Support Guide
water
witch
Electronic Water Leveller
12
PUMP OUT FROM TANK OR TROUGH
The Water Witch Smart Sense can be installed to pump water out of a tank,
trough or any other water body.
Instead of activating the fill function when the water level is low, programming and
an alternative installation enables the Water Witch to activate a pump when the water
level increases to a set height. The pump will continue operating until the water level
drops back below the sensor level.
OPERATING PROCESS:
• Sensor recognises when the water level increases to the preset maximum height
• Control Box activates relay switch
• Power passes through relay switch and activates pump
• Pump continues to operate until water drops below sensor level
At least
150mm
Balance line must
be higher than tank
capacity
Pump is activated when
water reaches Maximum level
Cable gland to
adjust sensor height
12v DC
Relay
Switch
Power
Supply
Sensor set to
Maximum water level
50mm balance line
Infinity Edge Trough
Standard
water level
Maximum
water level
Control
Box
DO NOT GLUE
50mm END CAP
Pump
NOTE:
A licensed
electrician will be required
to build a junction box
incorporating the 12v DC
Relay Switch.
