Product
Support Guide
water
witch
Electronic Water Leveller
11
INFINITY EDGE TROUGH
An infinity edge provides pool projects with additional design flexibility and creativity.
However, such designs pose additional challenges to ensure the pool operates
effectively and equipment is protected.
There are two crucial design factors to consider in relation to the required water level
within an infinity edge trough:
• A minimum water depth must be maintained within the trough to ensure enough
water is available to fill the pool and generate an overflow into the trough before the
trough runs dry. Failure to do so will most likely result in severe pump, equipment
and site damage.
• The water level in the trough may increase dramatically during a significant rainfall
event or heavy bather load. The trough capacity above the minimum water level
must sufficiently allow for this increase.
INSTALLATION OPTIONS:
• This diagram represents the
recommended installation
layout. Note that onsite
limitations may not make
this configuration possible.
• A second option is to use
the balance tank layout
on Page 10 for installation
within an infinity edge
trough.
•
Like the Balance Tank scenario, the water fill line should be directed to the highest
body of water so it is kept full and the excess then fills the trough.
At least
150mm
Balance line must
be higher than tank
capacity
Cable gland to
adjust sensor height
Sensor set to
desired level
50mm balance line
Infinity Edge Trough
Minimum
water level
Maximum
water level
Control
Box
DO NOT GLUE
50mm END CAP
