CONVEY-ALL CST-1634, Руководство оператора

Страница: 25 / 50

01.2016 3-7
Operator’s Manual: Commercial Seed Tender (CST-34 Series)
3.3 MACHINE BREAK-IN
There are no operational restrictions on the tender
when used for the first time.
The conveyor belt’s alignment is set at the factory, to
track correctly without carrying a load. It is important
to check alignment and make adjustments, if required,
during the first few minutes of operation.
It is recommended that the following procedural and
mechanical items be checked:
Before Starting:
1. Read the engine, trailer and CST operator’s
manuals.
2. Review the Pre-Operation Checklist before
starting machine.
At 1/2, 5 and 10 Hours:
3. Lubricate the points defined in Section 4: Service
and Maintenance.
4. Check the tension and alignment of the conveyor
drive systems. Adjust as required.
5. Check the conveyor belt’s tension and alignment.
6. Check hardware and fasteners. Tighten to their
specified torque.
7. If equipped, check the remote control. Be sure
that it functions properly.
8. If equipped, check engine and hydraulic fluid
levels.
After 10 Hours:
Go to the service schedule as defined in
Section 4.2 Servicing Intervals.
3.4 PRE-OPERATION CHECKLIST
Efficient and safe operation of the CST requires that
each operator reads the operating procedures. They
should also understand all related safety precautions
outlined in this manual. A pre-operational checklist
is provided for the operator. It is important for both
personal safety and maintaining the good mechanical
condition of the delivery system that this checklist be
followed.
Before operating the unit and each time thereafter,
the following areas should be checked:
1. Check engine fluid levels.
2. If equipped, be sure the battery is fully charged.
If needed, charge the battery before connecting it
with the battery cables.
3. Lubricate the machine per the schedule outlined
in the Maintenance section.
4. Check that the Folding Conveyor swinging frame
can move freely.
5. Check that the Folding Conveyor can fold freely.
6. Check that the conveyor belts are aligned and
tensioned properly.
7. Remove all entangled material.